Hi,
I'd like to ask, if it is possible to configure the AudioMoth without the App. It is not possible to run a graphical instance in my current configuration. There are two possible solutions for me: Config via USB from terminal or config from the sd-card (that will be switched - preferred solution). Has anyone done something like this and can point me in the right direction?
Thx in advance
Philipp
When you send 0x06 the next four bytes in the packet are used to set the time, so this data needs to be set to the correct time. Check the configuration packet that the Config App sends.
We have a future firmware version planned that will allow the type of remote configuration that you are implementing but haven’t started on it yet. To use the standard firmware you’ll need some way to activate the switch. On the AudioMoth Dev board the switch connections are brought out to a header and you can then use a relay or mosfet to control the switch settings.
Alex