Hi,
I'm trying to load a new firmware version. I'm following the steps from the tutorial (https://www.openacousticdevices.info/flashing), and when I reach step 5 (Enable Programming mode), after the LEDs stop flashing, a Windows pop-up letting me know a new device has been plugged appears, but it fails to install any drivers for the device, and I cannot continue de process (no new COM ports appear).
I use Windows 7 Pro. I've googled for drivers but been unable to find any.
Is there any drive/program or procedure that should be run/installed before attempting to flash?
Many thanks in advance,
We've updated the flash app to address the issues that you found. The new version, and updated instructions, should be up early next week. Alex