Hello,
I have a rather urgend problem. I am sitting in a hotel, and the plan was to retreave 10 AudioMoth from the field. Change vbatteries and SD Cards and reploy them. The problem is, i can not get them to connect to the TimeApp the ConfoigurationApp and the FlashApp. I tried EVERYTHING that was suggested in manuals and forum yesterday night. Nothing worked.
I have three AudioMoth that were in Acoustic configuration Mode once I set the switch to costum. And I was able to get then to record again to schedule. The other 7 have green and red LEDs constantly blinking and now matter what I do, that does not change. I think the problem is that my labtop does not recognize the devices. Eventhought I have successfully configured AudioMoth with this laptop before. I have updated all drives, as was suggested in one thread. No success. I bought a new Cable, no success. If I could get the other 7 manually to Acoustic Configuration Mode that would work for me. But I don´t get how this can be done.
I hope someone ready this soon😊
Best
Sandra
Hi Sandra, Did you manage to resolve this. If you remove the batteries, wait a few seconds, and the then replace the batteries the devices will go to acoustic configuration mode when switched to CUSTOM - solid red LED and flashing green LED. You can then use the smartphone app to set the time.
Do they all have the same version of firmware installed? Only version 1.5.0 supports persistent configurations with acoustic configuration mode.
Alex
Hello Sandra
If the green and red LEDs constantly blinking your AudioMoth is not ready to be configure. You followed setup-guide?
https://www.openacousticdevices.info/setup-guide
First you have to remove batteries. After step 3 your AudioMoth should be ready to be configured.
Best regards
Thomas