To test this feature, visit your live site.

AudioMothDev Switch Input - Suggestions for switch?

I am planning on using the onboard switch input on the AudioMothDev board and need to know what switches are available/suggested that will be waterproof? Would this one work...https://bluerobotics.com/store/comm-control-power/switch/switch-10-5a-r1/ ?? It only has ON/OFF so could I just use to turn on Default?

9 comments

9 Comments

Alex Rogers

Nov 17

The first recording was short because the AudioMoth was switched to CUSTOM in the middle of a recording period. The duration of the record/sleep cycle is 60 seconds, so all recordings should start on a round minute. The first recording started at 10:53:15 so was only 40 seconds long, so that all subsequent recordings fell onto the specified schedule.

Alex Rogers

Nov 17

Replying to

The low voltage cutoff triggers when the supply voltage to the processor drops below 2.8V. With a LiPo the actual battery voltage is typically then below 3.0V. It’s a bit hard to predict as the battery voltage in the WAV file headers is measured under quite light load but the supply voltage will typically drop when the battery is under load writing to the SD card.