I have few audio moth devices, i flashed new firmware on all of them. One among them is not recording anything in default or in custom mode, both red and green led flash together in both the modes. "Programmed" size and "Flash CRC" value were same as mentioned in the git hub after firmware upgrade, How can i resolve this and bring it back to working condition.
top of page
To test this feature, visit your live site.
Device not recording after flashing new firmware
Device not recording after flashing new firmware
7 comments
Like
7 Comments
bottom of page
I don't think it can be related to the firmware upgrade. If the CRC values are correct then the code is installed correctly and the device is working. I assume that you can also configure the device correctly by USB and that the time is updating correctly? The double flashing LED means the SD card write is failing so either it's a hardware failure or something inside the SD card slot preventing a good connection. Where are you based? Could you send us the device?