Hello! I appreciate your advice on designing an enclosure for Audiomoth USB MIC that will be permanently installed outdoors. The material should resist UV radiation and prevent moisture/rain to get inside electronics. Also, a sponge shield to prevent wind noise is a must. Dou you think a printed 3D unit will meet the required specs? Thanks in advance!
top of page
To test this feature, visit your live site.
Edited:Â Jul 21
IP6X Enclosure for Audiomoth USB MIC
IP6X Enclosure for Audiomoth USB MIC
1 comment
Like
1 Comment
bottom of page
I don't have any direct experience but I know colleagues have deployed 3D-printed ABS housings which have been through an acetone vapour bath to seal up any residual cavities in order to make them fully-waterproof: https://ultimaker.com/learn/how-to-3d-print-waterproof-parts/ The parts end up with a very smooth external finish.